LED R&D Lab(VD)
58
6. S-Box Installation and Connection
① Follow the steps below to access the Factory Menu.
- Connect the external IR cable to the S-Box.
- Press the power off button on the remote control Wait for 10 seconds Press Mute - 1 - 8 - 2
Click the “Power on” button
② In the Factory Menu, select Option MRT option SIMPLE WALL MODE SUPPORT ON
[Caution!] Do not run Simple wall mode if multiple S-Boxes are connected.
The S-Boxes may not display wallpaper simultaneously.
• Simple wall mode
This mode is used to easily display a wallpaper when you do not want the product to display a blank
screen while not in use.
If the screen resolution is smaller than the S-Box output resolution, use the Factory Menu to turn on the
Simple wall mode.
To Next Page
Loading...
