Samsung LE32C53 Series - Page 53

4-28
4. Troubleshooting
Control 
Control
Factory Name Data Range
EDID
Sub Option
Shop Option
Sound
EDID
Factory Name Data Use
EDID ON/OFF OFF
Download EDID data to EEPROM.
1. Set "ON" of EDID ON/OFF.
2. Go EDID WRITE ALL and Push Enter or ► button.
3. If You See Success message, SET "OFF" of EDID ON/OFF.
EDID WRITE ALL …
EDID WRITE PC …
EDID WRITE
HDMI
…
EDID WRITE
HDMI1
…
EDID WRITE
HDMI2
…
EDID WRITE
HDMI3
…
EDID WRITE
HDMI4
…
EDID 1.2 PORT …
EDID WRITE DVI …
Sub Option
Factory Name Data RANGE Use
RS-232 Jack UART Debug/Logic/UART
Select Setting of UART port.
Initial value is "UART"
Watchdog ON ON/OFF
Select Watchdog.
Initial value is "ON"
WD Count 0 255
Watchdog Count.
Read Only.
Dimm Type EXT xed
Select Dimming Type.
Initial value is "EXT"
Lvds Format JEIDA JEIDA/VESA/19INCH
Select LVDS format.
19inch : VESA"
other inch : "JEIDA"
OTN Server Type operating operating/development
OTN Test Server OFF OFF/ A/B/C/D/E Zone
OTN Support ON ON/OFF
OTN Reset not modifyed
OTN Duration OFF ON/OFF
OTN Fail Test OFF ON/OFF
T-CON USB
Download
Failure xed
View Log not modifyed