13
English
03 Basic Features
Satellite System Setup
The PIN input screen appears. Enter your 4 digit PIN number.
Satellite System Setup is available when Antenna is set to
Satellite. Before running Auto Store, set Satellite System
Setup. Then channel scan is run normally.
Satellite Selection ■ : You can choose the satellites for
this TV.
LNB Power (Off / On) ■ : Enables or disables the power
supply for the LNB.
LNB Settings ■ : Configures the outdoor equipment.
Satellite: Selects the satellite for receiving digital
broadcasts.
Transponder: Selects a transponder from the list or
adds a new transponder.
DiSEqC Mode: Selects DiSEqC mode for the selected
LNB.
Lower LNB Oscillators: Sets the LNB oscillators to a
lower frequency.
Upper LNB Oscillators: Sets the LNB oscillators to a
higher frequency.
Tone 22 khz (Off / On / Auto): Selects the Tone 22
kHz depending on the LNB type. For a universal LNB it
should be Auto.
Signal Quality: Display the current status of
broadcasting signal.
Positioner Settings ■ : Configures the antenna positioner.
Positioner (Off / On): Enables or disables the positioned
control.
Positioner Type (USALS / DiSEqC 1.2): Sets
the positioned type between DiSEqC 1.2 and
USALS(Universal Satellite Automatic Location System).
My Longitude – : Sets the longitude for my location.
My Latitude – : Sets the latitude for my location.
Satellite Longitude Settings – : Sets the longitude of
user defined satellites.
User Mode: Sets the position of satellite antenna
according to each satellite. If you store the current
position of satellite antenna according to a certain
satellite, when the signal of that satellite is needed,
the satellite antenna can be moved to pre-populated
position.
Satellite – : Selects the satellite to set the position for.
Transponder: – Selects a transponder from the list for
signal reception.
Moving Mode: – Selects the movement mode between
discrete and continuous movement.
Step Size: – Adjusts the step size degrees for the
antenna rotation. Step Size is available when Moving
Mode is set to Step.
Go to Stored Position – : Rotates the antenna to the
stored satellite position.
Antenna Position – : Adjusts and stores the antenna
position for the selected satellite.
Store Current Position – : Stores current position as
the selected positioner limit.
Signal Quality – : Display the current status of
broadcasting signal.
Installer Mode: Sets limits to the scope of movement
of satellite antenna or reset the position. Generally,
installation guide uses this function.
Limit Position (East / West) – : Selects the direction of
the positioner Limit.
Antenna Position: – Adjusts and stores the antenna
position for the selected satellite.
Store Current Position: – Stores the current position
as the selected positioner Limit.
Go to Zero – : Moves the antenna to the reference
position.
Reset Positioner Limit – : Allows the antenna to rotate
over the full arc.
Reset All Setting (OK / Cancel) ■ : All satellite settings will
be reset to the initial values.
¦ Editing channels
Channel Manager Option Menu
(in Channel Manager)
1. Select a channel and press the TOOLS button.
2. Edit the channel name or number using the Edit
Channel Name or Edit Channel Number menu.
Edit Channel Name ■ (analogue channels only): Assign
your own channel name.
Edit ■ Channel Number (digital channels only): Edit the
number by pressing the number buttons desired.
BN68-02631G_Eng.indb 13 2010-03-03 �� 8:38:14
To Next Page
Loading...
