Samsung LE37A686M1F - Scanning and Switching Anynet+ Devices

English - 57
Scanning and Switching between Anynet+ Devices
1. Press the TOOLS button.
Then press the ENTER
button to select "Anynet+ (HDMI-CEC)".
2. Pressthe▲or▼buttontoselect"SelectDevice",thenpress
the ENTER
button.
3.
Pressthe▲or▼buttontoselecttoaparticulardeviceand
press the ENTER button.Itisswitchedtotheselected
device.
4.
Ifyoucannotndadeviceyouwant,pressthe▲or▼button
toselect"Setup",thenpresstheENTER button.
5.
Pressthe▲or▼buttontoselect"SearchingConnections",
then press the ENTER button.
 Themessage"ConguringAnynet+connection..." is
displayed.
Whensearchingdevicescompletes,theconnecteddevicesare
listedintheAnynet+menu.
Switchingtotheselecteddevicesmaytakeupto2minutes.
Youcannotcanceltheoperationduringtheswitching
operation.
The
timerequiredtoscanfordevicesisdeterminedbythenumberofconnecteddevices.
Whenthedevicescaniscomplete,thenumberoffounddevicesisnotdisplayed.
AlthoughtheTVautomaticallyscansdeviceswhenitisturnedonusingthe
POWER
button,devices
connectedwhentheTVisonorunderaspeciccircumstancearenotdisplayedinthedevicelist.
Thereforeselect"SearchingConnections"menutosearchdevices.
IfyouhaveselectedexternalinputmodebypressingtheSOURCE
button,youcannotusethe
Anynet+function.MakesuretoswitchtoanAnynet+devicebyusingtheTOOLS button.
➣
➣
➣
➣
➣
Setup
Anynet+ (HDMI-CEC)
: On 
Auto Turn Off : Yes 
Searching Connections 
Move Enter Return
View TV
Select Device 
Record

Menu on Device 
Device
Operation 
Receiver
:Off 
Setup 
TV P9
Move Enter
Return
BN68-01684D-00Eng.indd 57 2008-07-04 �� 3:07:53