4-50
4. Troubleshooting
2. To enter User menu
Support - Software Upgrade - By USB then press the
ENTER button. The message USB searching...
It may take up to 30 seconds is displayed.
Please be careful to not disconnect the power or remove
the USB drive while upgrade is being applied.
Next message : refer to “Second picture”
Press the left, right button to select “OK”.
The TV will shut off after completing the rmware upgrade
Please check the rmware version after the upgrade is
complete.
* How to check Program Version
1. To enter Factory mode
2. Check the main micom version T-VALDEUS-XXXX
To Next Page
Loading...
