LED R&D Lab(VD)
88
① Remove the fixed screw of the HOLDER-PCB above the cabinet
• Remove all tops.
• The side removes only the HOLDER-PCB on the same line based on the module to remove
HOLDER-PCB
② Check the location of the
module to remove.
③ Remove the cable connected to
the module to remove.
(If the board covers the module,
separate it together)
Remove only the same onboard HOLDER
of the module to remove
Product disassembly method – 4) LED module replacement
□ Module disassemble
※ Cautions when disassembling modules
1. When replacing the module, make sure to proceed with the AC power cable unplugged.
2. Since this product cannot be serviced from the front, make sure to disassemble the module with the
cabinet separated.
To Next Page
Loading...
