2. Insert USB drive.
Menu -> Setup -> SW Update then press the ENTER button.
The message “Scanning for USB. It may take up to 30
seconds.” Please be careful to not disconnect the power or
remove the USB drive while upgrade is being applied.
The message “Upgrade version XXXX to version XXXX ?
The system would be reset after upgrade.”
Press the left, right button to select “OK”.
The TV will shut off after completing the rmware upgrade.
Please check the rmware version after the upgrade is
complete.
-. Upgrade uses USB onlay
-. Execute P&P after downloa
* How to check Program Version
1. To enter Factory mode
2. Check the micom version
T-TDT5IBRC
To Next Page
Loading...
