Samsung LT23A350 - Page 18

2-12
2. Product specications
 Troubleshooting for Anynet+
Problem Possible Solution
Anynet+ does not work.
• Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+
devices only.
• Only one receiver (home theatre) can be connected.
• Check if the Anynet+ device power cord is properly connected.
• Check the Anynet+ device’s Video/Audio/HDMI cable connections.
• Check whether Anynet+ (HDMI-CEC) is set to On in the System menu.
Anynet+ does not work.
• Check whether the TV remote control is in TV mode.
• Check whether the remote control is Anynet+ compatible.
• Anynet+ does not work in certain situations. (Searching channels, operating My
Downloads or Plug & Play (initial setup), etc.)
• When connecting or removing the HDMI cable, please make sure to search devices
again or turn your TV off and on again.
• Check if the Anynet+ Function of Anynet+ device is set on.
I want to start Anynet+.
• Check if the Anynet+ device is properly connected to the TV and check if the
Anynet+(HDMI-CEC) is set to On in the System menu.
• Press the TOOLS button to display the Anynet+ menu and select a menu you want.
I want to exit Anynet+.
• Select View TV in the Anynet+ menu.
• Press the SOURCE button on the TV remote control and select a device other than
Anynet+ devices.
• Press < CH >, CH LIST , PRE-CH, and FAV.CH to change the TV mode. (Note that
the channel button operates only when a tuner-embedded Anynet+ device is not
connected.)
The message
"Connecting to Anynet+
device..."appears on the
screen.
• You cannot use the remote control when you are conguring Anynet+ or switching to
a view mode.
• Use the remote control when the Anynet+ setting or switching to view mode is
complete.
The Anynet+ device does not
play.
• You cannot use the play function when Plug & Play (initial setup) is in progress.
The connected device is not
displayed.
• Check whether or not the device supports Anynet+ functions.
• Check whether or not the HDMI cable is properly connected.
• Check whether Anynet+ (HDMI-CEC) is set to On in the System menu.
• Search Anynet+ devices again.
• You can connect an Anynet+ device using the HDMI cable only. Some HDMI cables
may not support Anynet+ functions.
• If it is terminated by an abnormal situation such as disconnecting the HDMI cable or
power
cord or a power failure, please repeat the device scan.
The TV Programme cannot be
recorded.
• Check whether the antenna jack on the recording device is properly connected.
The TV sound is not output
through the receiver.
• Connect the optical cable between TV and the receiver.