Disassembly and Reassembly
3-7
Samsung Electronics
3.10 Main Board and Sensor Board
1. Before you remove the main board, you should
remove:
• Main Cover (see [3.1 Main Cover])
• SMPS board (see [3.9 SMPS Board])
2. Remove two screws from the main board and unplug
all of connectors, then remove the board.
3. Release four snap-fits securing the insulator engine
board and then remove the insulator.
4. Release four snap-fits securing the sensor board and
then remove the sensor board.
Main B’d
To Next Page
Loading...
