Samsung ML-1430 - Page 9

Disassembly and Reassembly
3-3
Samsung Electronics
3.4 Transfer Roller
1. Open the front cover.
2. Use a proper tool("-" type screwdriver) to pull the one
end of the roller slightly, then take it out.
3.5 FAN & Motor Assembly
1. Before you remove the motor assembly, you should
remove:
• Main Cover (see [3.1 Main Cover])
• Shield Engine Assembly
2. Remove one screws securing the Fan.
3. Remove five screws securing the Motor Assembly
and remove a connector from Engine Board(Engine
board and SMPS Board are integrated), then take the
Motor Assembly out.
XO
Shield
Ground
Note
When you reassemble the FAN, make
sure that the direction of the Fan is cor-
rect(the shield ground is downcast)