4.4
PRINT MEDIA
The printer has two output locations: the face-up output slot and the face-down output
tray. You can select the output location by changing the position of the output lever on the
front of the printer. To use the face-down output tray, be sure the output lever is in upper
(normal) position. To use the face-up output slot, push the output lever down.
• If paper coming out of the face-down output tray has problems, such as excessive curl, try
printing to the face-up output slot.
• To avoid paper jams, do not change the position of the output lever while printing.
The face-down output tray collects paper
in face-down order. To use, make sure
the output lever is in the upper position.
(If it is not, push it up)
The face-down output tray should be
used for most print jobs and is
recommended when printing large jobs.
The printer prints to the face-up output
slot if open. Push the output lever down
to open the slot. Paper will come out of
the printer face-up.
Using the face-up output slot might
improve output quality with the following:
• envelopes
• labels
• Transparency films
• paper heavier than 24 lb (90 g/m
2
)
Printing to the Face-Down Output Tray
Printing to the Face-Up Output Slot
Selecting the Output Location
To Next Page
Loading...
