4.10
PRINT MEDIA
Guidelines
• Only use labels recommended for laser printers.
• Verify that the labels’ adhesive material can tolerate a fusing temperature of 200°C
(392°F) for 0.1 second.
• Make sure that there is no exposed adhesive material between the labels. Exposed areas
can cause labels to peel off during printing, cause paper jams. Exposed adhesive can also
cause damage to printer components.
• Do not feed a sheet of labels through the printer more than once. The adhesive backing
is designed for one pass through the printer.
• Do not use labels that are separating from the backing sheet or are wrinkled, bubbled, or
otherwise damaged.
2
Push the output lever down.
1
Load labels in the input tray with print
side up.
Adjust the guide to fit the width of the
labels.
3
To print on labels, configure the paper
source, type and size in the software
application. For details, see page 5.3.
4
Press Demo to start feeding.
Note: To prevent labels from sticking, do
not let the printed label sheets stack up
as they are printed out.
Printing on Labels
To Next Page
Loading...
