4.12
PRINT MEDIA
1
Load letterhead into the input tray
with the design face up, bottom
edge toward the printer.
Adjust the guide to fit the width of the
paper stack.
2
To print on preprinted paper, configure
the paper source, type and size in the
software application. For details, see
page 5.3.
Guidelines
• Letterhead must be printed with heat-resistant ink that will not melt, vaporize, or release
hazardous emissions when subjected to the printer’s fusing temperature of 400°F
(205°C) for 0.1 second.
• Ink on letterhead must be non-flammable and should not adversely affect any printer
rollers.
• Forms and letterhead should be sealed in moisture-proof wrapping to prevent changes
during storage.
• Before loading preprinted paper as forms and letterhead, verify that the ink on the paper
is dry. During the fusing process, wet ink can come off preprinted paper.
To Next Page
Loading...
