Samsung ML-2015/XEV - Fuser

Disassembly and Reassembly
Samsung Electronics
Service Manual
5-9
5.2.9 Fuser
1. Before Disassembling
-Separate the font cover.(Refer to 5.2)
-Separate the SMPS cover.(Refer to 5.3)
-Separate the Main cover.(Refer to 5.4)
2. Separate 2 connectors from the SMPS and the Main
PBA as shown as below.
3. Separate the fuser by unscrewing 4 screws on the
frame. (Screw x 4:Gold_M3,6003-000269)
4. After removing the Lamp Cover L/R, separate the
Fuser Dummy cover.
5. Separate the Exit roller F/Down and the exit gear
(DRV17)by turning the left/right holder connected to
the exit roller F/Down to the arrow direction.At this
time,roller_main,roller_FR, F/Down Holder,and spring
are separated with theses.
Thermister
Fuser
Fuser Dummy Cover
Lamp Cover_R
Lamp Cover_L
Exit Roller F/Down
Holder
Exit Gear
F/Down Holder
Roller_FR
Roller_Main
Fuser