Samsung ML-2150 - Page 61

5-21
Samsung Electronics
Disassembly and Reassembly
Service Manual
5.23 Retard Ass’y
1. Before you remove the Retard Ass’y, you should
remove:
- MPF Ass’y (Refer to the 5.3)
- Main Drive Ass’y (Refer to the 5.7)
- Top Cover (Refer to the 5.13)
- Inner Cover (Refer to the 5.15)
2. Remove two screws. Then lift the Roller Ass’y,
as shown below.
3. Take out the Gear, as shown below.
4. Remove the lock equipment and rotate the
Bearing as shown below.
5. Slide the shaft (gear side) to the left side as
shown in the picture. Next, left side of the sjaft
to the right side. Be careful not to mass up with
the Holder Pad ass'y.
Roller Ass'y
1
2
Retard Gear
Bearing