Media and tray_12
2. Flex or fan the edge of the paper stack to separate the pages before
loading papers. Insert the paper into the tray.
3. After inserting paper into the tray, adjust the support guide so that it
lightly touches the paper stack.
4. Squeeze the paper width guides and slide them to the desired paper
size marked at the bottom of the tray.
• Do not push the paper width guide too far causing the media to
warp.
• If you do not adjust the paper width guide, it may cause paper
jams.
• Do not use a paper with more than 6 mm curl.
LOADING PAPER IN THE TRAY
Tray 1
1. Pull out the paper tray . And adjust the tray size to the media size you
are loading. (See "Changing the tray size" on page 11.)
2. Flex or fan the edge of the paper stack to separate the pages before
loading papers.
3. And place paper with the side you want to print facing down.
4. Squeeze the manual tray paper guides and adjust them to the width of
the paper. Do not force them too much, or the paper will bent resulting in
a paper jam or skew.
• Do not push the paper width guide too far causing the media to
warp.
• If you do not adjust the paper width guide, it may cause paper
jams.
• Do not use a paper with more than 6 mm curl.
5. Insert the tray back into the machine.
6. To print in application, open an application and start the print menu.
7. Open Printing Preferences. (See "Opening printing preferences" on
page 17.)
8. Press the Paper tab in Printing Preferences, and select an appropriate
paper type, size, and source.
9. Press OK.
10. Start printing in application.
If you experience problems with paper feeding, check whether the
paper meets the media specification. Then, try placing one sheet at a
time in the manual tray. (See "Print media specifications" on page 44.)
To Next Page
Loading...
