Supplies and accessories_ 101
• For Windows XP/2003, select Printers and Faxes.
• For Windows 2008/Vista, select Co
ntrol Panel > Hardware and
Sound > Printers.
• For Windows 7, select Control Panel > Hardware and Sound >
Devices and Printers.
• Fo
r Windows Server 2008 R2, select Co
ntrol Panel > Hardware >
Devices and Printers.
4. Righ
t-click your machine.
5. For Windows XP/2003/2008/Vista, press Properties.
• For PS driver, select PS driver and right-click to open Properties.
For
Windows 7 and Windows Server 2008 R2, from context menus,
select the Prin
ter properties.
If Printer properties item has ► mark, you can select other
printer drivers connected with selected printer.
6. In printer driver properties, select Device Options.
7. In printer driver properties, set the necessary options.
8. Click OK.
INSTALLING A WIRELESS NETWORK INTER-
FACE CARD
Depending on your country, wireless LAN cards may not be available.
Contact your local Samsung dealer or the retailer where you bought
your printer.
The machine is equipped with a network interface which
allows you to use
your machine on a network. You can also purchase a wireless network
interface card to enable the use of the machine in wireless network environ-
ments (See "Available accessories" on page 97).
Installing a wireless network interface card
1. Turn the machine off and unplug all cables from the machine.
2. Grasp the control board cover and remove it.
3. Take out a new wireless interface card from its bag.
4. Place the wireless network interface card into the card guide [below item
3], ensu
re the connector side of the card is to the right.
1 wireless network interface
card connector
2 wireless network interface
card
3 wireless network interface
card guide
5. Align the wireless network card connector on the right side of the card
with the connector on the control board [1].
Press the wireless interface card [2] down firmly into the main connector
[1] until it is
co
mpletely and securely in place.
1 Connector
2 Wireless inter-
face card
6. Close the control board cover by aligning the groove on it with the notch
on the printer and sliding it.
7. Plug all the cables back into the machine, and turn the machine on.
8. Set the wireless network environment.
For information about configuring and using the printer on a wire-
less network environment, refer to the Wireless network instal
l
guide provided with the wireless network interface card. You can
also configure the network parameters on the control panel; see
the next column.
To Next Page
Loading...
