Media and tray_ 46
LOADING PAPER IN TRAY
Tray 1 / optional tray
1. Pull out the paper tray. And adjust the tray size to the media size you are
loading. (See "Changing the tray size" on page 44.)
2. Flex or fan the edge of the paper stack to separate the pages before
loading paper.
3. Place paper with the side you want to print facing down.
Paper quantity indicator shows the amount of paper in the tray.
1 Full
2 Empty
4. Set the paper type and size for the tray. (See "Setting the default tray
and paper" on page 49.)
5. To print in application, see "Basic printing" on page 52.
Multi-purpose tray
The multi-purpose tray can hold special sizes and types of print material,
such as postcards, note cards, and envelopes. It is useful for single page
printing on letterhead or colored paper, please check maximum sheets you
can load based on thickness (See "Print media specifications" on
page 110).
Tips on using the multi-purpose tray
• Load only one type, size and weight of print media at time in the
multi-purpose tray.
• To
prevent paper jams, do not add paper
while printing when there is
still paper in the multi-purpose tray. This also applies to other types
of print media.
• Always load the specified print media only to avoid paper jams and
prin
t quality problems. (See "Print media specifications" on
page 110.)
• Fla
tten any curl on postcards, envelopes, and labels before loading
them into the multi-purpose tray.
1. Hold
the handle of multi-purpose tray and pull it down to open and
pull
out the multi-purpose tray paper extension.
2. Flex or fan the edge of the paper stack to separate the pages before
loading paper.
3. Place paper with the side you want to print facing up.
• When printing the special media, you must follow the load-
ing guideline. (See "Printing on special media" on page 47.)
• Wh
en papers overlap when printing using Multi-purpose
tra
y, open tray 1 and remove overlapping papers then try
printing again.
• When paper does not feed well while printing, push the
pap
er in manually until it starts feeding automatically.
To Next Page
Loading...
