Samsung MM-G25 - Buyer-Region Code Setting Method

4-12 Samsung Electronics
Troubleshooting
4-3 Buyer-Region Code Setting Method
4-3-1 The inserting method of Region Code after replacing the Main PBA
[Reference]
- When replacing the Main PBA and System Micom should be inserted the region code.
- The set is not working properly if you don't insert the region code.
- The region code is inserted by the remote control.
1. Press the “AUX” button on the remote control.
2. Press the “TUNER MEMORY” button on the remote control during
4~5 seconds.
3. Afterstep(2),youcansee“TEST−−”ontheVFD.
Insert number “3”, “3” to select Region Code.
4. Afterstep(3),youcansee“−−”ontheVFD.
Insert the Region Code corresponding model with
“0 ~ 9” buttons on the remote control.
5. Turn the Power off.
TEST − −
− −