GB
12
The timer enables you to switch the system on or off at specific times.
Example: You wish to wake up to music every morning.
If you no longer want the system to be switched on or off
automatically, you must cancel the timer.
Before setting the timer, check that the current
time is correct.
For each step, you have a few seconds to set
the required options. If you exceed this time,
you must start again.
1 Switch the system on by pressing On/Standby.
2 Press Timer/Clock until TIMER is displayed.
3 Press Program/Set.
Result: ON TIME is displayed (instead of the equalizer
symbols) for a few seconds, followed by any
switch-on time already set; you can set the timer
switch-on time.
4 Set the timer switch-on time.
a Set the hour by pressing TUNING and .
b Press Program/Set.
Result: The minutes flash.
c Set the minutes by pressing TUNING and .
d Press Program/Set.
Result: OFF TIME is displayed (instead of the equalizer
symbols) for a few seconds, followed by any
switch-off time already set; you can now set the
timer switch-off time.
5 Set the timer switch-off time.
a Set the hour by pressing TUNING and .
b Press Program/Set.
Result: The minutes flash.
c Set the minutes by pressing TUNING and .
d Press Program/Set.
Result:VOL XX is displayed, where XX corresponds to
the volume already set.
6 Press TUNING and to adjust the volume level and
press Program/Set.
Result: The source to be selected is displayed.
7 Press TUNING and to select the source to be played
when the system switches on.
If you select... You must also...
TAPE (cassette) Insert a recorded cassette in one of
the decks before setting the system
to standby.
TUNER (radio) a Select the FM or AM frequency
band by pressing TUNING Mode
and .
b Press Program/Set.
c Select a preset station by pressing
TUNING Mode and .
CD (compact disc) a Load a compact disc.
8 Press On/Standby to set the system to standby mode.
Result:
is displayed to the bottom left of the time, indicating
that the timer has been set. The system will switch on
and off automatically at the required times.
If the timer switch on and off times are identical, the word
ERROR is displayed.
After having set the timer, it will start automatically as shown by
the indication on the display. If you no longer wish to use the
timer, you must cancel it.
You can stop the timer at any time (system on or in standby
mode).
To... Press Timer On/Off...
Cancel the timer Once.
Result: is no longer displayed.
Restart the timer Twice.
Result: is displayed again.
Timer Function
To Next Page
Loading...
