Receiver & Display Unit Installation - Standard Type
Accessories
MRK-B00, B00U, B01, B01U
Receiver &
display unit (1)
Cable-tie (2) Cable clamp
(5)
M4 X 16 tapped
screw (7)
Owner’s
instructions(1)
Installation
manual (1)
Wire Kit
(Length:10m)
E-6
Remove the receiver & display unit cover by using the
tab on its bottom.
1
Open the receiver & display unit.
2
Connect the end of the connector wire to the receiver
& display unit and connect the other end of the wire to
the MAIN PCB (CN91) as shown in figure.
3
CC
CC
AA
AA
UU
UU
TT
TT
II
II
OO
OO
NN
NN
Do NOT keep the receiver & display unit cable
with a 220V cable because the remote controller
cables have low voltage.
◆
Receiver &
display unit
To Next Page
Loading...
