23
1. Introduction
Control panel
14
Control Panel
• When you use the display screen, use your finger only. The screen may be
damaged with a sharp pen or anything else.
• The screen may not operate or may not recognize touch inputs properly :
- If you attach an unauthorized protective film or accessory on the
screen.
- If the screen is covered with dust or any foreign substance.
- If there is any foreign substance between the display screen and
frame or if your other finger is touching the edge of the screen.
- If there is frost or moisture on the edge of the screen or if you touch
the screen with a wet finger.
• When the display screen is scratched or damaged, contact a service
representative.
1
Display screen
Shows the current machine status and prompts
during an operation. You can set menus easily
using the display screen.
2 Power LED Shows the power status of your machine.
3
(Power / Wakeup)
button
Turn the power on or off. When the blue LED is on,
the machine is powered on and you can use it. If
you turn the machine off, press this button for
more than two seconds. Then, confirmation
window appears.
4
Status LED
Shows the status of your machine (see
"Understanding the LEDs" on page 28).
To Next Page
Loading...
