Samsung MultiXpress M5370 Series - Finisher Failure #H2-5014. Turn off then On, after Checking Finisher; Finisher Failure #H2-5015. Turn off then On, after Checking Finisher

4.Troubleshooting
►ErrorCode
H2-5014
H2-5015
H2-5102
►Errormessage
FinisherFailure#H2-5014.Turnoffthenon,aftercheckingnisher
FinisherFailure#H2-5015.Turnoffthenon,aftercheckingnisher
FinisherFailure#H2-5102.Turnoffthenon,aftercheckingnisher
►Symptom
Stackeroperationisabnormal.
►Troubleshootingmethod
1)AretheStackerUpperLimit(Top)Sensors(S10)working?
a)Checkifthesensoractuator(SJ106332A)isabnormality.
b)Checkiftheconnector(SJ108370)ofthesensorsaredisconnected.
c)Checkiftheconnector(SJ108310)J8onthenishermainboard(JC81–07242A)isdisconnected.
d)Checkdiscontinuityanddamageoftheharness(SJ108310,SJ108370),replaceitifrequired.
e)Replacethestackerupperlimitsensors(S10).
f)ReplacetheFinishermainboard(JC81–07242A).
2)IstheStackerFullSensor(S16)working?
a)Checkifthesensoractuator(JR106210)isabnormality.
b)Checkiftheconnector(JR108320)ofstackerfullsensorisdisconnected.
c)Checkiftheconnector(JR108320)J18onthenishermainboard(JC81–07242A)isdisconnected.
d)Checkifthereiscontinuityintheharness,andifnotreplacetheharness(SJ108320),replaceasisnecessary.
e)Replacethestackerencodersensor(S16).
f)ReplacetheFinishermainboard(JC81–07242A).
3)IsthestackerLowerLimitSwitch(SW2)working?
a)Checkifthesensoractuator(JR106310)isabnormality.
b)Checkiftheconnector(JR108360)ofstackerLowerswitchisdisconnected.
Copyright©1995-2016SAMSUNG.Allrightsreserved.4-135