Samsung MultiXpress M537x series - Finisher Failure #H2-5009. Turn off then On, after Checking Finisher; Finisher Failure #H2-5010. Turn off then On, after Checking Finisher; Finisher Failure #H2-5011. Turn off then On, after Checking Finisher

4.Troubleshooting
►ErrorCode
H2-5009
H2-5010
H2-5011
H2-5100
►Errormessage
FinisherFailure#H2-5009.Turnoffthenon,aftercheckingnisher
FinisherFailure#H2-5010.Turnoffthenon,aftercheckingnisher
FinisherFailure#H2-5011.Turnoffthenon,aftercheckingnisher
FinisherFailure#H2-5100.Turnoffthenon,aftercheckingnisher
►Symptom
Ejectoroperationisabnormal.
►Troubleshootingmethod
1)Istheejectorhomesensor(S8)working?
a)CheckiftheEjectorhomesensoractuator(SJ102382)isabnormal.
b)Checkiftheconnector(SJ108360)ofejectorhomesensorisdisconnected.
c)Checkiftheconnector(JR108320)J7onthenishermainboard(JC81–07242A)isdisconnected.
d)Checkcontinuityandiftheharnessisdamaged,replaceitifrequired.
e)Replacetheejectorhomesensor(S8).
f)ReplacetheFinishermainboard(JC81–07242A).
2)Istheejectormovesveryfast?
a)CheckiftheEjectorEncodersensoractuator(SJ104362)isabnormal.
b)Checkiftheconnector(SJ108310)ofejectorencodersensor(S17)isdisconnected.
c)Checkiftheconnector(SJ108310)J13onthenishermainboard(JC81–07242A)isdisconnected.
d)Checkifthereiscontinuityintheharness,andifnotreplacetheharness(SJ10-8310),replaceasisnecessary.
e)Replacetheejectorencodersensor(S17).
f)ReplacetheFinishermainboard(JC81–07242A).
3)Istheejectormotor(M7)working?
4-128Copyright©1995-2013SAMSUNG.Allrightsreserved.