Understanding the fax screen
139
6. Scan & Send (Faxing)
Fax Options
If you send originals that are of poor quality, or contain photographs, you can
adjust the resolution to produce a higher quality fax.
• Resolution
- Standard: Usually recommended for originals with text. This option will
reduce the transmission time.
- Fine: Recommended for the originals containing small characters, thin
lines, or text from a dot-matrix printer.
- Super Fine: Recommended for originals containing fine details. This
option is only available if the receiving machine also supports Super
Fine resolution.
- Ultra Fine: Recommended for originals containing extremely fine
details. This option is only available if the receiving machine also
supports Ultra Fine resolution.
Book Scan
Use this feature to scan a book. If the book is too thick, lift the DADF until its
hinges are engaged by the stopper, then close the DADF. If the book or
magazine is thicker than 30 mm (1.18 inches), start copying with the DADF open.
• Off: Disable this feature.
• Left Page: Scans only the left page of the book.
• Right Page: Scans only the right page of the book.
• Both Pages(From Left): Scans both facing pages from the left page.
• Both Pages(From Right): Scans both facing pages from the right page.
• Book Center & Edge Erase: You can change the void area setting for the
binding around the entire book-edge; or for the center width and side
edges.
Advanced Fax (fax user only)
Set the sending options for fax, such as Quick Start Fax and Delay Send.
• Off: Disables this feature.
• Quick Start Fax: The machine will begin to transmit the fax right after the
first page has been scanned. Originals with many pages can be sent this way
without overflowing the machine’s memory.
• Delay Send: Set your machine to send a fax at scheduled time. Define the
Job Name and Start Time.
You can delay a fax by any length of time starting 1 minute and 24 hours
after the scan.
Email Settings
Set email information, such as From, Subject and Message.
To Next Page
Loading...
