339
3. Network setup
Network settings (configuring TCP/IP)
When you connect your machine to a network, you must first configure the TCP/
IP settings for the machine. The settings shown below are the basic settings
required for using your machine as a network machine. You can set TCP/IP, DNS
server, TCP/IPv6, Ethernet, and IP address allocation methods.
1
Ethernet
You can set ethernet settings.
Tap Settings > Network Settings > Ethernet from the home screen or Apps.
You can also use this feature from the SyncThru™ Web Service. Open the
Web browser from your networked computer and type the IP address of
your machine (see "Settings tab" on page 170).
• Ethernet Port: You can enable/disable ethernet port.
• Ethernet Speed: Choose the speed rate of ethernet.
• MAC Address: Shows the Mac address of the machine.
2
TCP/IP Protocol
You can set IPv4 settings.
Tap Settings > Network Settings > Ethernet > TCP/IPv4 from the home
screen or Apps.
You can also use this feature from the SyncThru™ Web Service. Open the
Web browser from your networked computer and type the IP address of
your machine (see "Settings tab" on page 170).
IP Setting
You can choose the method for allocating IP addresses.
• Static: Select to enter IP address/Subnet Mask/ Gateway Address manually.
• BOOTP: IP address/Subnet Mask/ Gateway Address are automatically
allocated by the BOOTP Server.
• DHCP: IP address/Subnet Mask/ Gateway Address are automatically
allocated by the DHCP Server.
To Next Page
Loading...
