Loading originals
48
2. Media and tray
2
In the Dual scan document feeder (DSDF)
Preparing originals
• Do not load paper smaller than 105 x 148 (4.13 x 5.85 inches) or larger than
216 x 356 mm (8.5 x 14 inches).
• Do not attempt to load the following types of paper, in order to prevent
paper jam, low print quality, and machine damage.
- Carbon-paper or carbon-backed paper
- Coated paper
- Onion skin or thin paper
- Wrinkled or creased paper
- Curled or rolled paper
- Torn paper
• Remove all staples and paper clips before loading.
• Make sure any glue, ink, or correction fluid on the paper is completely dry
before loading.
• Do not load booklets, pamphlets, transparencies, or documents with other
unusual characteristics.
Using the DSDF, you can load up to 100 sheets of paper (80 g/m
2
, 20 lb bond) for
one job.
1
Flex or fan the edge of the paper stack to separate the pages before
loading originals.
2
Load the originals face up into the DSDF. Make sure that the bottom of
the original stack matches the paper size marked on the document input
tray.
To Next Page
Loading...
