Samsung N5200 - Page 16

- 16 -
IP auto setting failed
1.
Configure the settings in IP Settings.
– Settings General Network Network Status IP Settings
2.
Make sure that the DHCP server is enabled on the router, and then unplug the router and plug it back in.
3.
Reset the router if required.
– For wireless connection, enter the correct password if required.
Unable to connect to the network
1.
Check all IP Settings.
– Settings General Network Network Status IP Settings
2.

it again.
– For wireless connection, enter the correct password if required.
Connected to a local network, but not to the Internet
1.
Make sure that the Internet LAN cable is connected to the router's external LAN port.
2.
Check the DNS values in IP Settings.
– Settings General Network Network Status IP Settings
Network setup is complete, but unable to connect to the Internet
If the problem persists, contact your Internet Service Provider.