9
Preparations
Chapter 02
Installation
Attaching the Stand
―
The color and shape of parts may differ from what is shown. Specifications are subject to change without notice to improve quality.
1 2 3
1
4
5
Put the stand base onto the stand neck as the direction shown in the figure. Check that the stand neck
is firmly connected.
Tightly fasten the connecting screw at the bottom of the stand base.
Hold the back of the product as shown in the figure. Push the assembled stand into
the main body in the direction of the arrow as shown in the figure.
6
4
7
Stand up the monitor and remove the package. Stand assembly is complete. Caution
Do not arbitrarily remove the panel film. If not observed, the warranty service may be restricted.
To Next Page
Loading...
