140
2. Using a Network-Connected Machine
IPv6 configuration
IPv6 is supported properly only in Windows Vista or higher.
9
From the control panel
Activating IPv6
Accessing menus may differ from model to model (see "Menu overview" on
page 26).
1
Select (Menu) > Network > TCP/IP (IPv6) > IPv6 Protocol on the
control panel.
2
Select On and press OK.
3
Turn the machine off and turn it on again.
When you install the printer driver, do not configure both IPv4 and IPv6. We
recommend to configure either IPv4 or IPv6.
DHCPv6 address configuration
If you have a DHCPv6 server on your network, you can set one of the following
options for default dynamic host configuration.
1
Select (Menu) > Network > TCP/IP (IPv6) > DHCPv6 Config on the
control panel.
2
Press OK to select the required value you want.
• Router: Use DHCPv6 only when requested by a router.
• Always Use: Always use DHCPv6 regardless of router request.
• Never Use: Never use DHCPv6 regardless of router request.
To Next Page
Loading...
