30
English
Advanced Features
Notice
The picture may appear corrupted or have static for some
channels when the TV is connected to the Samsung Wireless
LAN Adapter. In such a case, connect the Samsung Wireless LAN
Adapter using a USB cable in a place that is not affected by radio
interference.
✎
The Samsung Wireless LAN Adapter should be installed in an
interference-free area in order to avoid interference between
the adapter and tuner.
Method: Connect via an extension cable
Network Setup (Samsung Auto
Configuration)
This function is available in APs (Access Points) that support
Auto Configuration. If your AP does not support Auto
Configuration, you can connect through PBC (WPS), auto,
or manually.
✎
This function is available when SWL(Samsung
Wireless Link) is set to Off.
✎
You can check for equipment that supports Samsung
Auto Configuration on www.samsung.com.
How to set up using Samsung Auto Configuration
1. Place the AP and TV next to each other and turn them
on.
✎
Because the booting time of AP you may have to
wait for approximately 2 minutes.
✎
If the LAN cable connected the WAN port of AP
during Samsung Auto Configuration, you are able
to complete until internet connection test. If you
do not connect, Samsung Auto Configuration will
check only device connecting of AP (Not check
internet).
2. After 2 minutes, connect the Samsung Wireless LAN
Adapter to the TV. When the Samsung Wireless LAN
Adapter is established, the pop-up window appears.
3. As soon as a connection is established, place the AP in
parallel with the Samsung Wireless LAN Adapter giving a
gap no larger than 25cm.
4. Wait until the connection is automatically established.
✎
If Samsung Auto Configuration does not connect
your TV to your AP, a pop-up window appears on
the screen notifying you of the failure. If you want
to try again to use Samsung Auto Configuration,
reset the AP, disconnect the Samsung Wireless
LAN Adapter and then try again from Step1. Else,
you can choose one of the other connection setup
methods, PBC (WPS), auto, or manual.
5. Locate the sharer at the desired location.
✎
If the AP settings have been changed or it is the
first time you use the new AP after purchase, you
need to set up again beginning from Step 1.
or
[PC7000_Aus]BN68-02706A-01Eng.indb 30 2010-04-12 오전 11:24:55
To Next Page
Loading...
