3-2
3. Disassembly and Reassemble
Description & Screws Picture Description
3
Use Open Jig to release tape in corners and
all clips as indicated in red on sides and top &
bottom.
Gently lift up the Rear Cover starting at the
top being careful of function assembly at the
bottom.
When the 4 points (•
)Hook is broken.
Although the hook is broken, the appearance
of the Rear cover is no problem and Gap
problem is not appeard after re-assembly.
To prevent the Inner Hook's broken.•
1. Catch the upper section of the rear cover.
2. Open the rear cover from top to bottom.
If the wire is bent, need to change the wire.•
Open Jigs
BN81-12884A BN81-14946A
<Bottom Conner>
Jig Direction
Jig Direction
Jig Direction
Locking tabs locations
55"•
L : 6 point Locking
R : 6 point Locking
Top : 10 point Locking
Bottom : 9 point Locking
SIDE AV : 1 Point Locking
65"•
L : 7 point Locking
R : 7 point Locking
Top : 12 point Locking
Bottom : 10 point Locking
SIDE AV : 1 Point Locking
To Next Page
Loading...
