Samsung QRQ60T - Page 55

3-7
3. Disassembly and Reassemble
Description & Screws Picture Description
Remove the DC VSS-PD BOARD. (Decomposition
order :
1
-
2
-
3
)
75" / 82"•
1
Before Removing SMPS Board, You have
yo discharge the SMPS by using service
JIG.
If LED ON -> LED OFF discharge is •
completed.
<Before discharging> <After discharging>
LED ON LED OFF
Measurement point
2
Remove the SMPS Board pushing to the
arrow direction.
Pushing Connector A.1.
Insert the OPEN JIG like a picture.2.
Gently lift up (Top Left corner) to 3.
release the lock.
3
Gently lift up (Top Left corner) to release
the lock and Slide Board to the Right.
Locking Fixing Hole
A/S-DISCHARGE-JIG
BN81-12884A
Measurement point
Locking
Slide to the right to release the board
Bottom chassis Guide Fixing Hole
1
2
3
3