5. Position the Top Table(
2
) in place.
With a Philips head screwdriver, insert and tighten the 3
screws into the Top Table. With the door opened, reinsert the
Top Table cap(
1
) and close the doors.
When reattaching the top table, make sure that the
wires are not pressed or damaged by the top table.
2
1
4. Connect the water line (
5
) and then insert a
clip on the coupler with pulling tube.
Connect the one connector(
4
) on left side
door and two connectors (
3
) at each side
of the top cap.
3
4
To Next Page
Loading...
