English - 23
SETTING UP
4. After adjusting the doors, insert the supplied
fastener ( 6 ) using a pliers ( 5 ) in the gap
between the hinge-grommet ( 7 ) and the lower
hinge ( 8 ). The number of fasteners you’ll need
to insert depends on the gap.
2 fastener are enclosed with the
refrigerator.
The thickness of each fastener is 0.04”.
CONNECT THE WATER LINE
TO THE FRIDGE
• Connect the plastic line on the back of your
fridge to the cartridge holder outlet (fully insert
the plastic line to the cartridge holder outlet).
• Insert plastic clip to the cartridge holder inlet
and outlet.
• Turn water on and check for any leakage.
• You can purchase the necessary fi lter
cartridge at the retailer where you
purchased this refrigerator.
• The water line must be connected to
drinkable water only
• A compression fi tting and nut kit is
supplied with the unit and it is inside the
fridge drawer.
• When pushing the Refrigerator back,
make sure you don’t roll over the power
cord or water line(Icemaker supply line)
(Provided)
TO USE WITHOUT THE WATER
FILTER
Connecting to the water supply line
• Shut off the main water supply line and turn
the Ice maker to the off position.
• Locate the nearest cold water drinking line.
Household water line
Refrigerator
1. Slip the compression nut through the plastic
tubing.
2. After inserting the compression nut into plastic
tubing, tighten the compression nut onto 1/4”
compression fi tting(Provided).
DA68-02601F-00.indb 23DA68-02601F-00.indb 23 2014. 9. 16. 9:052014. 9. 16. 9:05
To Next Page
Loading...
