Select the location where the lter is to install.
•
If you wish to reassemble the water
inlet and outlet sides of the lter
during lter installation,see the
reference illustration.
•
Cut the water line attached to the
lter to the appropriate place after
measuring the distance between
the lter and the cold water tap.
Remove any residual matter inside the lter.
•
Open the main water tap to check
whether water is running through
the water tube on the water inlet
side of the lter.
•
If water does not come out
through the line,check whether
the tap is open.
•
Leave the tap open until clean
water is running out and any
residual matter that built up
during manufacturing has been
removed.
WATER LINE
FILTER
WATER
OUTLET SIDE
OF FILTER
Attach the lter lock stations.
•
Hold the lter lock stations in the
appropriate position (under the sink
for example) and x it tightly into
place where to screw.
TWO FILTER LOCK
STATION
TWO FILTER LOCK
STATION
Installation
To Next Page
Loading...
