Samsung RS6 N89 Series - Page 36

Installation
English36
Installation
Reverse osmosis water ltration system
The water pressure of the water supply system to a reverse osmosis water ltration
system must be between 241 kPa and 827 kPa.
The water pressure of the reverse osmosis water ltration system to the refrigerator’s
cold water line must be at least 276 kPa. If the water pressure is below the specied:
• Check if the sediment lter in the reverse osmosis system is blocked. Replace the lter
if necessary.
• Rell the water tank in the reverse osmosis system with water.
• If your refrigerator has a water lter, it may further reduce the water pressure when
used in conjunction with a reverse osmosis system. Remove the water lter.
For more information or servicing, contact a licensed plumbing professional.
Ordering a new lter
To purchase a new water lter (part type: HAFEX/EXP), contact a local Samsung service
centre.
To mount the water lter into place
1. Attach the lock clips (x2) to appropriate
positions under the sink, for instance.
Then, x the lock clips rmly using
screws.
CAUTION
Do not mount the water lter on any part
of the refrigerator. This may damage the
refrigerator.
2. Insert the water lter into the upper
and lower clips in the correct direction.
Make sure to check the vertical
direction of the water lter.
NOTE
If the lter is installed horizontally, water
may remain in the lter. Therefore, vertical
installation is recommended.
Water lter replacement (applicable models only)
CAUTION
• Do not use third-party water lters. Use only Samsung-provided or -approved lters.
Untitled-1 36 2018-05-04  5:04:59