34_ operating
TOUCH SCREEN CORRECTION
You can calibrate the stylus touch point to best meet your needs. To adjust the stylus touch point on the
touch screen:
1. Touch the
button in the bottom right corner of the Settings list.
2. Touch Screen Correction in the Settings list.
3. Touch the Yes button. A screen appears with pointer instructions on the top.
4. Press down lightly on the center of the “+” mark. Repeat as the “+” mark moves across the screen.
If you do not touch the center of the + properly, the cross mark appears repeatedly.•
If you cannot run the Touch Screen Correction function in Settings because the touch screen input point
is incorrect:
1. Touch and hold the Settings icon on the home screen for 5 seconds.
This will launch the touch screen calibration function.
2. The screen will display a series of cross icons.
Touch the exact center of each cross icon as it appears on the screen.
S/W UPDATE
Lets you check the current software version and update it to new software when available.
1. Touch the button in the bottom right corner of the Settings list.
2. Touch S/W Update in the Settings list.
DA68-01312H(0.0).indb 34DA68-01312H(0.0).indb 34 2012.2.16 5:2:54 PM2012.2.16 5:2:54 PM
To Next Page
Loading...
