Maintenance
English54
Maintenance
Sealing guard (applicable models only)
To remove the sealing guard
Gently lift up the guard, and then pull it to
the front while holding the bottom side.
To reinsert the sealing guard
1. Put the guard on the front of the
housing. And then, insert the guard by
lowering it.
2. Press both hooks on the guard to lock
the guard. When the guard is locked
properly, you will hear a clicking sound.
CAUTION
• Make sure the sealing guard is locked rmly. Otherwise, the guard may cause noise
when you open or close the door.
Untitled-11 54 2016-02-15 4:32:42
To Next Page
Loading...
