English
Hinge Low
1. Lay down the set.
CAUTION
• Must working more than 2 people.
• Be sure to unplug the Power Cord before
performing the operation above.
2. Disconnect Hose.
(Only Hinge Low Left)
3. Exhaust Water in Hose.
(Only Hinge Low Left)
4. Remove Bolt(3ea).
(Using spanner or 10mm Box wrench)
5. Remove Hinge Low L/R.
6. Reassemble in the opposite order of
disassemble after replacing the top,
middle, and/or bottom hinge.
CAUTION
• Make sure the wire connectors are
connected properly.
• Be careful not to damage the wires when
fastening the top cover.
RS8000NC_2Door_User-servicing-manual.indb 9 2021-01-27 7:39:14
To Next Page
Loading...
