Samsung RS6HA8891SL/EU - Water filter replacement

Installation
English36
Installation
CAUTION
Do not mount the water lter on any part
of the refrigerator. This may damage the
refrigerator.
Water lter replacement (applicable models only)
CAUTION
• Do not use third-party water lters. Use only Samsung-provided or -approved lters.
• Unapproved lters may leak and damage the refrigerator, causing electric shock.
Samsung holds no responsibility for any damage that may occur from use of third
party water lters.
• The lter indicator turns red as a reminder that lets you know it is time to replace the
water lter.
1. Shut off the main water supply.
2. Connect the water supply line to the
inlet side of the lter to the end.
3. Connect the dispenser line to the outlet
side of the lter.
4. Check if there is any leak. If not, x the
lines with the clips.
5. Put the water lter into place and x it
with the clips.
6. Press and hold Filter Reset for
3 seconds to reset the lter lifecycle.
7. When replacing is complete, ush 10
litres of water (or dispense the water
for 6 - 7 minutes) to remove impurities
from the water line.
Untitled-6 36 2021-01-06  5:02:16