11
S49CG93*S
1 2
Put the stand base onto the stand neck
as the direction shown in the figure.
Check that the stand neck is firmly
connected.
Tightly fasten the connecting screw at
the bottom of the stand base.
3
4 5
Push the assembled stand into the main body in the direction of the arrow as
shown in the figure.
Stand up the monitor as shown in the
figure.
Separate the box from the product.
6
Stand assembly is complete. Caution
Do not arbitrarily remove the panel film.
If not observed, the warranty service
may be restricted.
To Next Page
Loading...
