English _15
● INSTALLATION & CONNECTION
CONNECTING WITH OTHER DEVICE
Connecting to the monitor
Connect the video out port of the camera to the video input port of the monitor.
M
In the initial installation of the camera, you can connect the camera to the monitor for checking
the connection status.
When connecting a general monitor device to the HD-SDI video output, you need to use a signal
converter.
You can set the video output type to either NTSC or PAL. (page 29).
Video Cable
The cable connecting the camera’s video output and a monitor is a BNC coaxial cable as
shown below.
If the distance between the camera and the monitor exceeds the recommended maximum,
please us an auxiliary video amp.
Maximum video transfer
distance
Recommended cable
specification
100~140m 5C2V(75ohm)
200m
L-6CHD(75ohm)
(SDI-specific Cable)
HD-SDI
POWER
C-Video
GND
AC 24V
DC 12V
1 : GND 4 : RS-485+
2 : EXT_D/N 5 : RS-485-
3 : MD_OUT
1 2 3 4 5
HD-SDI Monitor
Motion detection output device
Test monitor for
installation
Day/Night mode
controller
To Next Page
Loading...
