installation & connection
16_ installation & connection
External Day/Night Switching Input
Day/Night mode of the camera can be switched by signal from an external device.
M
To use this function, <DAY/NIGHT> setting of the camera should be set to the <EXTERN>.
(Page 27)
Motion Detection Signal Out
Upon a motion detection, the port outputs signal for an external device for display or operation.
When a motion is detected, the port outputs 3.3V signal.
M
To use this function, <ALARM OUT> setting of the camera should be set to <ON>. (Page 30)
Power Supply
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.
J
Be careful not to reverse the polarity when you connect the power cable.
Be sure to turn the power off the device to be connected.
For AC/DC Power Supply
You can use either one of AC 24V/1A~2A and DC 12V/2A~4A adaptor.
HD-SDI
POWER
C-Video
GND
AC 24V
DC 12V
1 : GND 4 : RS-485+
2 : EXT_D/N 5 : RS-485-
3 : MD_OUT
1 2 3 4 5
RS232C RS485, 422
CONVERTER
T+ T- R- R+
or
DVR
System Controller
PC
POWER
RS-485 Converter
To Next Page
Loading...
