Samsung SCD-2020 - Exposure Setup Details; White Balance Settings

COLOR DOME CAMERA User Guide
18
COLOR DOME CAMERA User Guide
19
Operating Your Camera

BRIGHTNESS : Adjusts the video brightness.

SHUTTER : You can select the shutter.
- ESC : Select this to control the shutter speed automatically. If ESC is selected, the
shutter speed is automatically controlled depending on the ambient
illumination of the subject.
- MANUAL : You can control shutter speed manually.
NTSC:x512~x2,1/60~1/120,000sec
PAL:x512~x2,1/50~1/120,000sec
- A.FLK : Select this when you experience picture flicker, this happens when there is
a clash with the installed lighting frequency.

AGC (AUTO GAIN CONTROL) :
The higher the gain level, the brighter the screen - but the greater the noise.
  -OFF:DeactivatestheAGCfunction.
  -LOW:Allowsautomaticgaincontrolfrom5.3dBto32dB.
  -HIGH:Allowsautomaticgaincontrolfrom5.3dBto37dB.

SENS-UP :
When it is night or dark, the camera automatically
detects the light level and maintains a clear picture if
this mode is activated.
- OFF : Deactivates the SENS-UP function.
- AUTO : Activates the SENS-UP function.

RETURN :
Select this to save the changes in the EXPOSURE menu and return to the SETUP menu.
MAIN SETUP
1.LENS SHADE ON
2.EXPOSURE
3.WHITE BAL ATW
4.SSDR
OFF
EXPOSURE SETUP
1.BRIGHTNESS 25
2.SHUTTER ---
3.AGC HIGH
4.SENS-UP OFF
5.RETURN
•Ifyouset the Function Setup switch to‘AUTO’ mode, you can adjustthe brightness by
increasingordecreasingtheshutterspeed.(x2~x512)
•Notethatthehigherthezoomlevel,thebrighterthescreen,butthemorelikelyitisthatan
after-imagewillappear.
•AlthoughNoise,Spots,andWhitishsymptomsmayoccurinSENS-UPoperationwhenthe
zoomlevelisincreased,thisisnormal.
Notes
•Settheshuttermodeto---ifcolorrollingoccurs.
•When the SHUTTER is set to ESC after selectingtheInternal SynchronizationType, the
picture may become unstable if the camera faces a bright fluorescent light. Therefore,
take care when choosing the installation position.
•WhentheSHUTTERissettoMANUALorA.FLKmode,SENS-UPwillbedisabled.
Notes
Use the White Balance function to adjust the screen color.
1. When the SETUP menu screen is displayed, select ‘White Bal.’ by using the Function
Setup switch so that the arrow indicates ‘White Bal’.
2. Select a desired mode using the Function Setup switch.
White Bal (White Balance)
 Select one of the following 5 modes, as appropriate for your purpose.

ATW : Select this when the color temperature is between 1,700˚K and
11,000˚K.

OUTDOOR : Select this when the color temperature is between 1,700˚K and
11,000˚K. (sodium light inclusion)


INDOOR : Select this when the color temperature is between 4,500˚K and
8,500˚K.