Samsung SCD-2080R - Page 20

20_ setup
setup
Select a desired mode using the Function
Setup switch.
BRIGHTNESS : Adjusts the video brightness.
SHUTTER : You can select either auto or
manual shutter.
A.FLK : Select this when you experience
picture fl icker, which can happen
when there is a clash with the frequency of the installed lighting.
ESC : Select this to control the shutter speed automatically. If ESC is
selected, the shutter speed is automatically controlled depending on
the ambient illumination of the subject.
MANUAL : You can control shutter speed manually.
(NTSC MODEL : 1/60~1/120,000, PAL MODEL : 1/50~1/120,000)
--- : Shutter speed is fi xed at 1/60sec(1/50sec).
Set the shutter mode to --- if color rolling occurs.
When the SHUTTER is set to MANUAL or A.FLK mode, SENS-UP will be disabled.
AGC (AUTO GAIN CONTROL) :
The higher the gain level, the brighter the
screen but the higher the noise.
OFF : Deactivates the AGC function.
LOW : Allows automatic gain control
from 5.3dB to 32dB.
HIGH : Allows automatic gain control from 5.3dB to 37dB.
SENS-UP : When it is night or dark, the camera automatically detects the light level
and maintains a clear picture if this mode is activated.
OFF : Deactivates the SENS-UP function.
AUTO : Activates the SENS-UP function.
If you press the Function Setup switch in ‘AUTO’ mode, You can adjust brightness by adjusting
the SENS-UP level. (x2 ~ x512)
Note that the higher the SENS-UP level, the brighter the screen, but the more likely it is that an
after-image will appear.
Although Noise, Spots, and Whitish symptoms may occur in SENS-UP operation when the
sens-up level is increased, this is normal.
If GAIN of EXPOSURE is not in use, the SENS-UP is set to “---“.
2.
y
y
-
-
-
-


y
-
-
-
y
-
-




EXPOSURE SETUP
䯝 1.
BRIGHTNESS
IIIII
Â
IIIIIIIIIIIIIIII
25
2.SHUTTER
---
3.AGC HIGH
4.SENS-UP OFF
5.RETURN
LIMIT
䯝 AUTO x2
Press SET to Return