English - 19
● CONNECTION & INSTALLATION
CAMERA ID DIP SWITCH SETTINGS (SW1)
Assign a unique number to each camera to identify itself from the others.
In coaxial communication systems, the camera will work normally only if the Camera ID DIP switches (SW1)
are all positioned to OFF.
The switch is set to “ID: 1” by default, and 7 switches other than
switch 1 are all set to OFF.
Each switch has a unique value, and the board ID is the sum of
the values of the switches.
Refer to the example below for the board ID.
Example 1
Example 2 Example 3
1+2 = 3 (Board ID = 3) 4+32 = 36 (Board ID = 36)
1+2+4+8+16+32+64+128
= 255 (Board ID = 255 )
Use a unique ID for each Camera.
1.
2.
M
ON
OFF
ON
ON
OFF
SW1
To Next Page
Loading...
