Service Manual
Precautions
5-14
Samsung Electronics
5.8 Middle Cover & Exit Roller
1. Before you remove the Middle Cover and Exit Roller,
you should remove:
- Rear Cover (see page 5-2)
- Side Cover (LH, RH) (see page 5-3)
- Scanner Ass'y (see page 5-5)
2. Remove the 4 screws securing the Middle Cover and
remove it.
3. Remove 2 screws securing the Controller Shield Ass’y
to the Middle Cover. Unclip the Middle Cover from the
Frame Ass'y, as shown below. Take care to release
the Shield Ass’y locating pegs and lift the Top Cover out.
4. Remove the Exit Gear and Bearing, as shown below.
To Next Page
Loading...
