Precautions
Service Manual
5-21
Samsung Electronics
5.16 Drive Ass'y
1. Before you remove the Drive Ass'y, you should
remove:
- Rear Cover (see page 5-2)
- Side Cover (LH) (see page 5-3)
- Shield Controller Ass’y (see page 5-9)
2. Remove the 5 screws securing the Drive Ass'y.
3. Take out the Drive Ass'y, then unplug the connector
from the Motor PBA, as shown below.
Caution. The six screws have numbers stamped. into
the Drive Ass’y base plate. When refitting the
Drive Ass’y tighten the screws the order they
are numbered. Only screw s numbered 1 to 5
are fitted at this stage. Screw 6 is fitted when
the Shield Controller Ass’y is refitted
5.17 Cover Mid Front
1. Before you remove the Cover Mid Front, you should
remove:
- Rear Cover (see page 5-2)
- Side Cover (LH, RH) (see page 5-3)
- Middle Cover (see page 5-14)
2. Remove the 4 screws securing the Cover Mid Front
and release 2 clips in the center. This cover is fragile
take care when removing it.
To Next Page
Loading...
