Precautions
Service Manual
5-25
Samsung Electronics
5.20 Pick-Up Ass'y & Solenoid
1. Before you remove the Pick-Up Ass'y, you should
remove:
- Rear Cover (see page 5-2)
- Side Cover (LH, RH) (see page 5-3)
- Front Cover (see page 5-4)
- Scanner Ass’y (see page 5-5)
- Middle Cover (see page 5-14)
- Controller Shield Ass,y (see page 5-15)
- Engine Shield Ass,y (see page 5-16)
- Drive Ass'y (see page 5-20)
- Feed Ass’y (see page 5-23)
2. Remove the Pick-Up Gear Ass,y.
3. Take out the Pick-Up Ass'y, as shown below.
4. Remove the 2 screws securing the Manual Solenoid
and Pick-Up Solenoid. Then remove Manual Solenoid
and Pick-Up Solenoid.
5. To replace the pick up roller, move the stopper secur-
ing the sponge-roller to the right and then turn the
sponge-roller to remove it from the shaft.
When replacing either the MP pick up roller or main
cassette pick up roller only, it is possible to do this by
turning the set over after removing the cassette and
the processor. See page 5-26
To Next Page
Loading...
